DIN CASE FOR SONOFF BASIC R2 Width = 1.5 module (1 circuit breaker = 1 module)

Content to print:

• 1 box
• 1 cover
• 1 spring clip
• 1 pusher
• 2 cable clamps

Use :

• The push button on the front panel activates the card button (on / off).
• A hole in the front allows you to see the LED

Assembly, integration into the board:

• Place the spring clip in its housing (respect the direction of the profile in relation to the din rail)
• Cut the front tab print support at the bottom of the case (see photo)
• Insert the pusher into its hole and turn it until it slides without friction
• Clip the Sonoff card under the rear tabs, then the front tab
• Wire the terminal blocks, tighten the cable clamps
• Screw on the cover (3 countersunk head screws M2.5-12)
• Place the box on the din rail and block the spring clip

IF YOU LIKE THIS OBJECT, PLEASE LEAVE A LIKE, A COMMENT OR A MAKE.