I found my Ciclop 3D Scanner to be more useful as a laptop stand, so I harvested the metal parts and made this. I eventually wanted my laptop at an angle, so I modeled a middle section of my own, but you can still use the ciclop center tower and just bend the rods to achieve the same effect.

I included my very messy SCAD, in case you want to change the angle or dimensions.

3D Printed Parts: 1x left foot 1x right foot 1x front support 1x center tower

Metal (or Nylon) Parts: 4x M8x170 mm threaded rod 2x M8x235 mm threaded rod (I trimmed the 400mm rods that come with the ciclop) 24x m8 nut 18x m8 washer

Other Parts: 1.5mm EVA Foam Double Sided Tape or Spray Adhesive (Supper 77) to affix the foam to the bottom of feet and tower, and if you want the front support.