Bike Wall Mount Angled, Various sized Tires, Fits Most Clipless Pedals

Simple, Pick Tire Size

Print Pedal capture and 2 Blocks Sized for you tires see STL names for rough sizes.

Find Studs if you can, Hold Bike Up in Position (may require more than one person) Mark Pedal Holder location, put bike down Important screw into Stud, or use appropriate anchor Important to attach to wall Raise Bike Put Pedal into holder (DO NOT APPLY FULL WEIGHT YET) WHILE Holding make sure wall mount side of crank arm (Thing that pedal is attached to) is vertical (Straight Up-pedal highest point) With Bike level from front to back add wheel chocks, these take most of the weight so pedal holder is only holding weight of bike at angle.

NOT RESPONSIBLE FOR BAD MOUNTING OR BAD PRINTS, USE YOUR BRAIN.

Done, Admire bike and how cool it looks on your wall!

Wall Mount Large V2 - designed to accept larger pedals, Note to avoid excess material usage print as shown, Designed for a #10 screw at least 5" long.