This has been fully remodeled inspired by karilawler version.

The changes include:

• Simpler polygons geometry in termos of the 'B' and groves around it resulting on faster prints.
• 3.5mm thickness with 0.8mm groves
• 40mm diameter
• 2 sided

The result shown in the pictures are using the following settings in Cura 4.4:

• Layer Height: 0.2mm

• Line Width: 0.4mm

• Wall Thickness: 1.2mm

• Wall Line Count: 3

• Bottom Layers: 9999

• Infill 100%

• Print Speed: 60 mm/s

• Wall Speed: 45mm/s

• Top/Bottom Speed: 25mm/s

• Initial Layer Speed: 15mm/s

I used an override between layer 6 and 12 to speed up the filling part of linear layers:

• Outer Wall Speed: 45mm/s
• Inner Wall Speed: 55mm/s
• Top/Bottom Speed: 70mm/s

These settings result on my printer 28mins for a single coin, around 2h30 for 6 coins and Cura predicts it will take around 6h for 15 coins.