This is a simple, quick to print, mod to the Saitek/Logitech Flight Simulator Throttle Quadrant that adds stop gates for the throttle about 25% from the lower range. This allows for a reverse gate for throttle or a feather gate for prop, or a cutoff gate for mixture. Easy to set up with X-Plane 11 and other Flight SImulators.

I printed in PLA and no finishing required. The handle tops on the throttle can be pulled off to allow the part to slide down over it. Then you can attach the stop blocks with a single acrew. No springs necessary as gravity does the work of holding the levers down until lifted by your fingers.

WATCH THE VIDEO BELOW FOR A FULL DEMO AND EXPLANATION