Really not a fan of the lure keepers that use the little rubber o-rings, general pain in the a** to use and I've lost count of how many I've had to replace when the O-ring pings off and I don't notice. I wanted something simple, discreet, secure and dead easy to hook on an off from no matter the size of hook. So I came up with this little thing.

Diameter of the rod seat is 11.5mm so should fit a wide variety of rods. the zip-tie is 1.2mm thick and 3mm tall.

Printed in ABS at 0.1mm layer height with a 0.4mm nozzle. no supports needed but best printed dead slow. took 28mins to print.