This cable clip is designed for the Oculus Quest to hold the Link Cable out of the way while you are gaming. It is made so that it fits where the headstrap curves downwards so that it stays out of the way of earphone and routes the cable perfectly behind your back just like the Oculus Rift.

It works with any cable that is 5.5mm in diameter or less, so this should work with most USB cables and also with the official link cable when it's released.

• Print in any material (I used PLA)
• Print on edge and no supports needed
• 20% Infil is recommended with 3 walls/bottom/top layers.
• I used a brim, but may not be needed depending on how good your bed adhesion is.

Place the clip onto the headset as close to the front as possible, then slide to the back to make getting it on easier. Opposite to get it off.