Speedcube V.0.71

The goal is to design a Speed-Cube 100% printable in PLA / PETG / ABS etc. Not quite there yet. The spring was harder than i expected. At the moment you will need to find 6x springs.

Assembled the cube is: 45x45x45mm Its recommended to print the pieces as they appear, especially the mid-piece! I designed it for 0.2 res. but i recommend 0.1!

You will need to print: 6x Center-pieces 8x Corner-pieces 12x Mid-pieces 6x Lockers 1x Frame 8x Caps of your choice on each of the 6-sides. (the center and locker serves as the 9th)

None-printable parts: You will need 6x springs, approx. 5-10mm long and 5-8 mm in diameter.

Good to know: First time you assemble, start with pushing each locker onto each leg of frame and turn it clockwise 90º. Else it can be hard to get it in place with centerpiece and spring in place. If its to tight fit to get it on(depending on the first layer) turn it upside down with "+"-side first(diameter is a bit more on this side) Do not try to lock it, just push it straight down with the 2 dots on the locker aligned with the channels on the frame.