Made a simucube 2 wheel side QR to use with my rally wheel and other low NM games (it can take a beating as its quite oversized and been tested at 20NM until i couldnt move the wheel due to fatigue with high fidelity ) or cars. Its 50mm tall 70mm pattern. Its about 85mm wide on the pattern side. Could be slightly to wide so any feedback is great. May need to reduce to 80-82mm t

Edit: Prototype: It may have a ever so slight bit of up/down play but it depends on the printer and setup. This can be fixed should you need it by adding a printed shim around 0.5mm thick to the inside on each of the narrow sides and it should be very solid. Same for the wider side 0.25. It may not be needed. Added to download 0.5 0.25 Print 2 of each.

I recommend that you print from 48mm and up solid as it will take most of the load.

I used PLA for its hardness. Works great for the solid top part. Expect 10-12 hour print time.

I printed mine with 70% infill and solid from 48mm and up. Im sure you can get away with a lot less infill though. 40% is probably fine. The top double the size compared to the metal to handle the forces

Let me know in the comments what you think

16/08/20: Added 35mm 60mm 70mm. Untested. 02/01/21 Removed 35-60mm. Fusion 360 bugs and scales the object when adding length to only the center. I dont understand why.

Edit 260521

I see several people has issues with the current versions. I do not understand why to tell you the truth as the models looks fine on my Prusa slicer and in Fusion 360. I saw it had created an error when i extended one earlier and i pulled that but i could not find anything on the others. My apologies for any was to of time and plastic.

I have removed the 70mm for now. I never touched the original