Stackable Sieve ==========

Sieve frame with insert to take a wire mesh approximately 150mm (6 inches) square. The outside is 155mm square which is the largest that will fit on my print bed. The sieve has a coarse mesh to support your wire mesh or with no support if you are not giving it hard use. I provide a pot to catch your powder. There is a lid which can be useful when shaking the sieve.

Print the box, cut your sieve mesh to fit using the insert as a size guide then glue all in place with an impact adhesive.

This should be printed in a plastic with good layer adhesion. Use PLA or PETG as ABS will warp.