Another candle mold design to cozy up your Halloween night!

Creating one is simple:

Source candle wax and wick (you can melt store bought candles for both) Print all parts (PETG or similar high-ish temperature plastic recommended) Insert the wick in the slot Lock the mold with the two rings and seal the gap of the two halves with tape etc. Melt the wax to around 70 degrees C (158 Freedom units) Cast the candle and let it cool before separating the mold Enjoy DIY candle light!

Some waxes shrink when cooling, so you might want to fill in the cavity formed by this. Cut the wick before this for a clean bottom, which can be leveled with melting the excess wax off by pressing the candle on a hot surface.

Check out my other designs here: https://www.thingiverse.com/Superbeasti/designs