This is a prototype Micro Spider-H Quad I've been working on. The design is intended to replace the conventional wood designs that most people use for H-Quads. The arms are angled outwards at 25 degrees so that any load encountered during a crash will be felt mostly as an axial load rather than a perpendicular load. The center spine is arched upwards slightly, partially for aesthetics and partially because it helps the arms form a stronger bond with the spine. I haven't been able to test/weigh this quad yet.

This Micro Spider H-Quad is designed to work with the following components:

Turnigy 1811 2900KV Motor Turnigy Plush 6A ESC KK2.0 (or any controller with 45mm hole spacing) M2 Shouldered Screws (for mounting the controller and the motors)

The print will require support material - some below the spine arc and some below each of the arms, as they are all filleted.