An adapter which makes it possible to shoot Nerf Darts with a drain blaster through special capsules.

Instructions:

Printing:

1st Side: Print on the side that connects to the drain blaster Use supports 50% infill 4 perimeters

2nd Side: Print on the side that connects to the drain blaster Use supports 50% infill 4 perimeters

Single Shot Capsule: Print on the side that connects to the adapter Use supports 5% infill 4 perimeters

Triple Shot Capsule: Print on the side that connects to the adapter Use supports 5% infill 4 perimeters

Ten Shot Capsule: Print on the side that connects to the adapter Use supports 5% infill 4 perimeters

Assembly:

Materials you will need: 6 m3 screws 25mm or cut to fit 6 m3 nuts 12 3mm washer 1 15mm×2,5mm o-ring 2 60mm×2,5mm o-rings(per capsule)

Main Blaster:

Put the drain blaster between the 1st and 2nd side. Put a washer on each screw and screw them in. Before you put the nut on, place another washer on the screw so that there is a washer on each side. Put the nuts on and tighten them. Then place the small o-ring in the slot on the small connector piece.

Capsule: Put the two big o-rings in the slots for the o-rings.

WARNING: DO NOT AIM OR SHOOT AT HEAD OR EYES! USE AT YOUR OWN RISK!