I needed some dead angels for hellish terrain, and I figured with Descent Into Avernus coming soon, some of you might as well. These are remixed using Curufin's dead villagers and warriors, so you can use the same print settings.

I may come back later and add nail heads sticking out of the wings for vertical mounting, but I got tired tonight.

UPDATE (8/15/19): After printing all of these out, I have discovered that the wings may be a bit too thin. I knew they would be prone to curl due to how thin they are, so I printed them with a brim, and this may have been a mistake as it is very hard to remove without damaging the wings. I am going to mess around with these and see if I can make some improvements ASAP.

UPDATE (8/18/19): I made the wings thicker on Male A and got much better results. I'm having some trouble with some of the models, as the thicker wings overlap some of the limbs and weapons and I'm not good enough to blend those well. I'll publish what I can, and hopefully that will be enough to work with.

UPDATE (8/18/19): The only other mini I could get to look right with the thicker wings was Female E. This will probably be it for the foreseeable future. If anyone else wants to do better versions of my idea, let me know! I'm excited to see what folks with actual talent can pull off.