Lockpicking gun (design concept):

the design and build instructions are not complete! things may change. feel free to submit your ideas and improvements.

1. print all parts and smooth all inside parts!

2. buy a metal measuring tape or use an old one (e.g. https://www.amazon.de/dp/B0078E23NI/ref=cm_sw_em_r_mt_dp_U_rAivDb692EG6Q)

3. cut a 5cm part from the measuring tape.(will act as a special spring ...)

4. use the 2 trigger parts and glue them together.

5. cut the measuring tape sides to fit between the trigger and the lever.

6. glue the mesuring tape on the lever and take a m3 screw to fix the lever. (but keep it move smooth)

7. follow the picture to complete the whole snap gun:

8. the back side of the handle is adjustable if you use a m3 screw with 2 bolts you can configure the spring pressure.

Log: 15.08.19: (Blender file only)

• Allow more spring pressure.
• Pressure stick spring cut and fix.
• snap part allowed movement wall.
• deeper trigger hole impress.