This is the first part of my cable management. I placed the electronics box farther back and raised the feet of the printer. I made this because of the cables that were too short.

Required: M4x25 4pcs M5x15 1pcs M3x8 4pcs M3 T-nut 4pcs

Increase printer feet:

• Print 4x Ender5_Feet_Extender_V1.stl
• use the 4x25 to attach

Electronic box:

• Print 4x Ender5_Lower_Box_V3.stl
• Use the existing M5 to attach the print to the box, apart from the m5 at the power input use an M5x15 for this
• Attach the box with the M3x8 and t-nuts to the frame

Note: All cables are the original lengths and are not adjusted.