should print mostly without supports

use the little groves in the backplate to line up the letters and the backplate might need a little sanding on the feet to slot into the top of the poles

I was able to print the power poles without supports at .2mm but I did use Z-hop

the biter can be a little tricky to make small

Edited some files there were mistakes/easier to print models I also added a combined letter plate for pausing the print to switch filaments to orange

Edit2 Added a tileable base with the train to slide on the tracks. Added rotating turrets Added a FDM friendly biter use a heat gun or warm water to gently bend legs into poses.

Tip: I highly recommend using PVA (Elmers) glue just smear a coating on the base and sprinkle some sand or dirt on to create the terrain