A module based paint stand. I made one of my sections 10mm lower since I have one set of smaler "sample" size pots.

Can be used individually or in a tower as I have done in the picture. I cutted a pipe that was 15 in outer diameter and 13 in inner diameter. I measured the height of the parts that I used get to the lenght of the pipe. It is made with a 5mm spacer so you could make the pipe almost 5mm shorter. (the spacer is to strengthen the foot)

I use a tube to fix the hexes in place by pushinging it through one of the outer hexes. I have uploaded center rings that you could print instead ( will upload picture later on)

I used one M8 socket screw about 30-40mm long to both the top and foot to fix it in place by expanding the split rod. I used a Standard socket screw to the top and a countersunk to the foot

Changelog 2019-07-28 I have changed design sligtly on both top and foot to make it easier to assemble

New parts: Citadel_foot_02 Citadel_top_02 Center ring 01 ( made to fit into the center hex) Center ring 02 ( made to fit into the outer hexes)

If you like my stuff please send a Paypal tip so that I can buy more sets. :D Will focus on Warhammer Underworlds, Necromunda and Warcry.