Created a simple, adjustable vertical stand to save space when storing laptops. Supports laptops from 20 - 41mm thick by adjusting the two set screws on each side of the stand. Simply tighten when the desired width is reached in order to securely hold your device. Tested with a heavy, all aluminium Ultra book to great success so should accommodate a wide variety of laptops. Prints in 10 pieces with no supports required. I used 30mm chrome audio feet for my example pictures. I also used countersunk washers as i like the aesthetic they produce however these are not essential for assembly. If you do wish to use them, the print file is available on my account. All you would need to do is use countersunk screws all around in the dimensions listed below. I recommend adding some foam padding to the braces in order to avoid potential scratches/ marks to your device from repeated use. Can follow me on my Insta for more unreleased and upcoming designs: noyceprints

You will need to print:

1 x Stand base 2 x Side braces 2 x Inner braces 5 x 30mm feet

Hardware required:

5 M3x10mm screws for the feet. 6 M3x10mm countersunk screws for the side braces. 4 M3x20mm screws for the adjustable inner braces.