The Cube-RT (rotating towers) desktop organizer was designed for the AutoDesk Fusion 360 Makerbot Challenge. This is my first design project for a competition, but I have used Fusion 360 in internships as well as various classes.

STL units are in inches.

Some renders use free use pre-fab models to give an idea for how the device could be used.

Overview: The Cube-RT is a desk organizer that can be opened and closed by rotating any of the three top cubes to the right. This causes the other two cubes to rotate in unison, revealing 5 different shapes for desk storage. The bottom middle has two swinging doors and a sliding drawer for larger storage. Returning the organizer to its default position conceals the items stored within and minimizes desk clutter.

Components:

Base.stl

The main body of the organizer, has two storage spots. The cup on the left is ideal for sticky notes, and the cup on the right is designed for pens.

Cube 1.stl

Cube 1 is split into two storage areas, a cup on top, and a small triangular shelf on the sides. The cup is ideal for a small plant, or for spare change.

Cube 2.stl

Cube 2 contains one large shelf, which could be used to hold one's keys or other desk supplies.

Cube 3.stl

Cube 3 is clearance for the pen cup on the base. It can't hold anything itself but is necessary to give pens enough room when the organizer is closed.

Rod.stl (2x)

These rods stick halfway into the base, and halfway into cubes 1 and 3. These are about .23-.25" diameter, and 7.75" long and should be made of a light metal.

Half Rod.stl

This rod sticks into the base, and into cube 2. It has a .23-.25" diameter, and is 4.125" long.

Sliding Drawer.stl

This drawer fits into the middle of the base, and can slide towards or away from the user. This tray is large enough to hold a stapler, tape dispenser, or most smartphones. A rectangular hole on the back of the base allows for a phone to be charged while stowed.

Swing Door.stl (2x)

These doors fit into the slots in the base, and enable access to the sliding drawer. The hinge is uniquely designed to allow the doors to swing on their corner, without showing the hinge from the closed view.

W Bracket.stl

The W bracket sticks small pegs into the bottoms of cubes 1, 2, and 3. This piece is necessary to get all 3 cubes to rotate in unison.