A Bender head. Planned to house a Raspberry Pi (or other SoC) inside. No mounts for the board yet.

Please note, it's a work-in-progress, and only been test-printed at 50% scale (about 100mm height without antenna, shown in the photo), parts' fit might be off in places at different sizes.

Supports needed for head shell and eyes.

Current issues:

• Clips holding the visor to the head are a bit weak and can snap easily, need to be reworked. Not an issue if you glue the whole thing together.
• Eyes have holes for pupils. Still undecided if pupils should be separate or attached to the eye mounting plate.

123Design original file is included.