• Usable with different Key types
• Mountable with 2 Screws, glue or double-sided tape (screws preferred)
• Under desk or wall assembly, your choice

Best results with PLA / ABS, 2 Perimeter, 3 full Top/Bottom Layers, 50% honeycomb infill with a 0.4 mm nozzle.

If your printer melts the feather holder gap with the bottom, you must cut them free.

The pictures shows a print in green ABS (1.75 mm)

• Sliced with Slic3r 1.0.0r2
• 2 Perimeter
• 3 full Top/Bottom Layers
• 30% honeycomb infill
• 0.2 mm Layer height
• Perimeter Speed 50 mm/s

Printed on my custom style Delta with a 0.4 mm Hexagon Hotend.