Remix info:

• I remixed this from energywave's "Intex pool bended outlet" thing: 2425707.

Which pool is this for?

• According to energywave, it should fit Index pools which have an output diameter of 81.25mm (measured with a caliper)

• I measured my Coleman pool and it appeared the same. It fit perfectly.

Changes I made:

• I made the outlet part into a longer tube. Energywave was trying to make the water flow in a certain direction, this was designed for water to splash.

• I resized the ring. X and Y were both scaled up by 2%. Z was left alone. Before this, it was impossible to get started. With the change, it easily screws on and is still tight enough to stay put.

Key points:

• The tube part stays in place but you can twist it in a full 360 degrees and point it in any direction.

• No support material needed.

• Print the ring last as if you need to resize it, it is the quickest to reprint.

Disclaimers:

• I have had no ill effects on my pump and neither has Energywave with their original design. But I can make no claims if this will have any impact on your pool pump.

• The tube is purposefully not taken to a sharp point for safety, but still, be cautious around it.

Additional Credits:

• Energywave used knurledFinishLib by aubenc to create the awesome grips.