This will let the nozzle head hit the switch and turn off the printer. Make sure to use wire and a switch who can handle the load! Also since this is AC I recommend switching both + and - wires, and connecting the earth together. Also the switch holder doesn't have a cable hole, so put the cables tough it before soldering them!

====== 0.2mm tolerance pre-set

====== 'Switch_Holder' is for mount it to the X as itself (you lose 2cm of your bed) use 'X200' to hit the switch 'Switch Holder X' is for mounting over the X as-tensioner, adjust the X end code as needed (I think it needs to be X220 or something) 'Switch Holder X V3' is for mounting with an X belt tensioner (https://www.thingiverse.com/thing:2986144) offset is 'X235' so only 1mm of the printing area is lost [BEST SOLUTION]

====== Needed:

• 2x M3 bolt and T nut
• Switch "8553vb" from "Arcolectric" https://produktinfo.conrad.com/datenblaetter/700000-724999/700088-da-01-en-Wippenschalter_gruen_beleuchtet_bedr.pdf

if you are going to print V3 then https://www.thingiverse.com/thing:2986144

====== Add the following line to your printers end code:

G1 X235; Automatic shut down ====== Changelog:

• Added 'Switch Holder X' to get back more bed space; X200 needs to be adjusted for this in your end code!
• Added 'Switch Holder X V3' this would get almost all bed space back, but you need to print thing:2986144 too.
• Added 'Finger V2' as requested, this has a bigger finger end, and should hit the switch better if you have problems.

Know issues V1 LOST 35MM OF BED [Known, not going to fix] V2 LOST 15MM OF BED [Known, not going to fix] V3 LOST 1MM OF BED [Known, can't fix]