Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
A simple and effective design for a joint holder ring.
The joint is kept secure due to the shape of the holes.
It should be inserted in the wider ellipse and come out through the thinner one, as to fit the cone of the roach. This change in shape creates a small amount of pressure on the roach stopping it from falling out. Both ellipses have the same circumference, if the circumferences were not the same, the roach would pass through but it would wrap itself tighter and become smaller, which can affect how smoothly it smokes.
The ring comes in 17 different finger sizes, from 15.6 mm to 22 mm in 0.4 mm increments.
The roach size is the approximate diameter, and each ring size comes in 3 different roach sizes, giving a total of 51 different variations.
I've tested it out at 0.2 mm layer height to see if the leafs still print and it works good. I'd recommend doing it at 0.1 mm though.
Gostou deste modelo? Crie uma conta grátis para salvar seus favoritos e voltar a eles depois.
Criar conta