OpenSCAD FPV camera mount generator.

TL;DR ==================== + Edit the first 6 settings + Don't bother changing $fs + Render too see curves and save STL + Dimensions are in mm + Visit http://www.openscad.org/ for the software to render this

Using the Generator ==================== Simply change the variables to suit your frame, camera and preferred amount of camera up-tilt.

There are sensible defaults set for most of the variables so you only really need to change a handful of them for most applications (example below). If using OpenSCAD you will need to do a proper render to see the curved corners due to the way the fillets are built. You will also need to render it before you can export a STL file for printing.

If you don't have OpenSCAD installed you can use the 'Open in Customizer' button to generate your STL file. This does seem a bit buggy though so your mileage may vary.

Common Settings ==================== The common settings you need to change are as follows: Example is for a FPV Flightclub Proton - Runcam Sparrow Micro - 2.1mm lens

// centre to centre standoffSeparation = 31; // width of the camera body at the mounting screw point cameraWidth = 19; // outer diameter of the lens lensInnerDia = 12; // from the centre screw to the back of the lens ring lensOffset = 7; // how far the camera sits inside the frame, use negative values to sit forwards cameraInset = 0; // amount of material around the lens lensRingThickness = 2.4;

Feedback & Suggestions ==================== I've only used this to make mounts for two different quads and cameras so far, so if you have any suggestions for improvements please let me know in the comments.