This is a remix of the "Thrust Vectoring Mount for 29 mm rocket engines". It is constructed for building your rocket with an R/C motor for first hovering tests. There is also a version for the 29mm rocket. The remix is almost half the size, can tilt 8 degrees on each side, has landing legs holders inspired by falcon 9 and a lower rocket body. The inner vector mount parts are slightly shiftet away from the rocket body, so the lower body will not collide with its tilting parts (image). This lower body has room for a lipo battery (3S, mine is 60 x 31 x 19mm) with some holding structure for the pcb's. The upper part has screw holes and a protections for sensors. The parts have screw holes in it to srew other rocket parts on them. The thrust vector mount can be printed all together in one go, with some concentric support, 20%. Sensors: GY68 BMP180: https://www.ebay.ch/itm/GY68-BMP180-Replace-BMP085-Digital-Barometric-Pressure-Sensor-Board-Arduino/200915895472?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649 Pro GY-521 MPU-6050: https://www.ebay.ch/itm/Pro-GY-521-MPU-6050-Module-3-Axis-gyro-3-Axis-Accelerometer-Module-Arduino-DF/153156852497?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649 Screws: M4/M3.5 x 8 for connecting the rocket parts with each other and mounting the vectoring mount, M3 x 6 for mounting the sesnros