Book Hide (small)

A book-like container for all your things in need of a place to hide!

Create your own cover, either in the Customizer/editing the .scad file or just drawing a 54x70x1mm square, with 45 chamfered edge on the bottom and add your own mix in to it. All remixes/makes are welcomed!

Check out the large version here: https://www.thingiverse.com/thing:3593742

The book is assembled as follows:

Separate the two sides of the Cover after printing.
Remove the built in supports under the hinge and the lock pin.
Clean all finish all parts.
Do a test fit, make sure the Upper and Lower Pins go in all the way without resistance and spin freely, and the pages fit nicely.
Insert the pins and glue the Pages to the back cover (this goes over the pins ends, locking them in place).
Hide your things.

Check out my other designs here: https://www.thingiverse.com/Superbeasti/designs

Descrição