Designed in Fusion 360, using influences from bag style clips/spring clips. This is the first time I've ever designed for a non bespoke use case, so felt like giving back to the community, any and all suggestions/comments gratefully received!

There are 3x variants of holder and cases.

Holders:

x8 Micro SDs + SD Card adapter x12 Micro SDs x3 SD Cards

Cases: x1 Holder width - Text "Micro SD" x1 Holder width - Text "SD" x2 Holder width - Text "Card Storage"

Notes:

Micro SD are a drop in fit, they do not retain in place, easy removal by pushing down on the small end of the card and sliding them out.

Printed without support, but did require some tidying with a file on the overhang for the clip cutout on the case.

Test prints in Prima Value Blue PLA at 200 degrees Hot End with 60 degree bed on CR-10