This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/7eKViH8MW06

Out of necessity based on Mburr cover. be careful to remove the support its a 0.40 seperation above and below.

Support integrated. no support needed in slicer.

Tip : push nodge between 2 fingers and remove the support with slim pliers gently from left to right and pull it. This worked for me perfect.

Remember its a tight fit in the WII i managed to push it in with some degree of push manipulation.

Please if you like the model and planned to make it please post a make https://www.thingiverse.com/thing:3504969/make I would appreciate a nice cup of coffee during modeling and it helps me a lot by supporting me. https://www.paypal.me/Vanvoorn