Modular mount system =================

This is a set of parts allowing you to mount anything (almost) anywhere. I needed a flexible desktop torch mount and then I just went ahead with more and more parts.

Note, this thing is more a reboot rather than remix - I designed everything from scratch, though general idea follows yyh1002's modular mounting system. Since mine is compatible with GoPro as well, they might be compatible with one another, but I did not tested it.

The package contains of the following:

• Short/Medium/Long bar (60/80/100 mm). Simple bars - working horses of the mount system.
• Short/Medium/Long angular bar - bars with hinge raised above the bar, though both hinges are at the same angle.
• Micro/Small/Medium/Long change bar - regular bar, though one hinge is rotated 90 degrees to the other one. Micro change bar is an "in-place" change bar, with hinges only.
• Base-3, Base-4 - 3-legged or 4-legged stable base - simple mount, just place it on flat surface (desk, floor etc.)
• Short/Medium/Long base leg - legs for bases (40/60/80 mm).
• Screw - general purpose screw, used in almost all places. Use M5x30 screws with hex head and M5 nut.
• Vice + Vice screw + Vice screw top - a vice (see photo). I recommend printing the vice parts with 0.1mm layer height, since there's a thread and ball joint.
• Torch holder - my initial holder for Castorama torch (on photos).
• Small/Medium/Long fixed angle bar - bars with hinges designed to lock themselves on 0/45/90 degrees.
• Mobile mount base / Mobile mount slider - montage for mobile phone. Use M5x60 screw with hex head and a M5 nut.
• Tripod + TripodLeg - a simple 3-legged tripod. Each leg can either end with small foot (TripodLeg) or can be fixed using other part of the system.
• TripodMount - conversion from a regular tripod to my mount system (may not work with all tripods though)
• Small cam holder - micro holder for small camera (eg. Mobius). Use standard tripod screws.
• Medium cam holder - a little bigger holder for camera (eg. compact one). Use standard tripod screws.

Keep in mind to set up parts properly and generally avoid printing hinges pointing to Z axis, because they will be weak and may break easily. Hinges in parts, which need to be printed towards Z axis (such as bases) have a little bigger hinges, but be careful with those too.

Print with supports when needed, they should be easily removable.

Almost all parts tested on PLA / 50% infill.

I include full Fusion360 archive file, such that you may design your own parts. All dimensions are parametrized.