A toy Bear Trap I designed for a friends son to catch all those pesky bad guys skulking around the house!

There are 2 versions,

V1 - smaller parts, requires cardboard for teeth/jaws and base support. See the above video for instructions on how to build that.

• Both V1 parts
• Pins
• Trigger

V2 - Bigger! Full Jaws and base, can use double thick cardboard or print the tooth in TPU for maximum FUN!

• Both V2 parts
• Pins
• Trigger
• Tooth x21 (Optional, TPU @ 20% infill. Less infill for softer teeth)

Materials

• Plastic! Printers preference! I used PLA for all but the teeth.
• Rubber bands
• Superglue, for the pins.
• Cardboard for V1 or V2 teeth.
• TPU for optional teeth.

All but the pins can be 20% infill. Pins must be 100%

I only used support for the pins just to keep them from breaking loose but you may need a brim because of the caps. They will probably need some knife cleanup.

V2 will need more rubber bands then V1 because more mass.

This thing has a hair trigger! If it's not staying set then just add more rubber bands.

Set and Enjoy!