Hey guys this is the Elusive Phantom. Remixed from Meaker's MK15, Ive made alot of changes and upgrades to not only make it more reliable and stylish but also designer friendly. As you will see from the pictues there and many differnt things you can do with the files to really make the blaster fit your tastes so have fun with it . Listed below are some assembly tips as well as the changes I've made. As of now Im getting 140 to 150fps with my remixed 42mm ofp cage, worker high crush wheels and fang revamp motors.

Assembly:

This blaster will use M3 dome head screws of various lengths for 98% its assembly. The flywheel cage however is held in by standard nerf sized screws.

Holes will have to be drilled for the side plates as I wanted to keep these optional as they are purely cosmetic.

The rev switch can ether be mounted with apoxy or have holes drilled for it depending of your preference.

The Pusher and trigger shims may need light sanding, as well as the cover and opening for your volt meter

The spring for the mag release should be heated up and melted into the notch on the mag release lever. This has been the easiest way I have found to keep it in place permanently under heavy gameplay.

Wiring on this blaster is a little unique so if you guys have any questions feel free to message me, but here is a short summary of how i recommend running them. From the flywheels both wires are ran down through the channel in the rail and into the opening at the top front of the grip . From here the posotive wire can go directly into the battery compartment while the negative wire is ran through a channel behind the pusher and down to the rev switch. From here there are a couple options to run the rest of your wiring back up to the battery compartment so use which ever works best for you. Wires for your volt meter are ran through the same channel ibehind the pusher and into the battery compartment where they can be soldered onto you +/- leads

Changes:

-Custom cage based of OFPs 42mm -New pusher system for a more reliable and smoother trigger pull -Volt meter -Wiring Channels -Integrated magwell plate to protect battery -Vented Flywheel cover -Reinforced cage mounting posts -Mag Release Relocated and redesigned -Flared Magewall

• Side Deco Plates for emblems/logos -Magwell redesign
• Front end redesign for easy motor and flywheel removal

Link to original design https://www.thingiverse.com/thing:2957944/files