This modular mini table foot consists of a mounting bracket and modules and allows you to use table feet with a height of 20mm, 40mm, 60mm, 80mm (and so on) by simply stacking the neccessary number of modules onto each other and onto one mounting bracket. Each module (including the mounting bracket) is 20mm high. So you would need to print 1 mounting bracket and 2 modules to produce one mini table foot with a height of 60mm.

I also added some other module shapes and sizes to the modular mini table foot: These modules are also 20mm high and 40mm or 30mm in diameter. The top modules with 40mm in diameter hide the connection to the mounting bracket. Together with the mounting bracket the height is 40mm.

You can combine those modules in more or less any way you like.

No glue neccessary - the modules will be kept in place by friction only.

Depending on the quality of your filament and your printer settings it might be quite hard to push the first module into the mounting bracket. In this case please pull the module out of the bracket and rotate it by 90° and try again. You might have to repeat this process several times.

Update 2019-02-19:

New mounting bracket added: the larger and oval screw holes make the alignment of the bracket much easier, when fastening the screws - this is especially important, when you use modules, that are not round. The photos still show the older mounting brackets.

New modules added: rounded corners with edges

Update 2019-03-09:

New modules added: round 40mm with edges