Inspired by this GPU support https://www.thingiverse.com/thing:3283357 but the designs are so different I didn't end up calling this a remix.

This is a GPU support bracket for an NZXT H700i or NZXT H700 case. It fits my GTX 1080ti Founders Edition, which means it should also fit a GTX 1080 FE. I haven't tested it with any other cards.

I have an NZXT Kraken G12 GPU cooler on my card, so it doesn't have any of the stock cooling underneath the PCB.

The NZXT logo will need a bit of post-printing cleanup since I included a few 0.5mm supports. Just cut them out with a small knife. Print it without any additional supports.

Components: NZXT H700 GPU Support Bracket: 1x NZXT H700 GPU Support Bracket Backside: 2x 10mm m3 screws: 2x m3 hexagonal nuts: 2x

I would suggest you print this in PETG since the inside of your case may get a little toasty sometimes.