Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
This is a MIDI controller which can almost fully be made from scratch!
The required materials for making this MIDI controller are as follows:
You will need:
-
16 30mm SANWA arcade pushbuttons ( or anything with the same pinout, NOTE: CHEAP ARCADE BUTTONS DO NOT WORK, THEY HAVE DIFFERENT PINOUTS THAN QUALITY ARCADE BUTTONS SUCH AS SANWA or HORI FOR EXAMPLE )
-
32 female fuse clip connectors to connect the buttons to the PCB ( https://www.digikey.ca/product-detail/en/keystone-electronics/3557/36-3557-ND/2092485 )
-
Teensy micro controller
-
Blank PCB
-
PCB Transfer paper
The included PDF should be printed at 100% onto transfer paper for making the PCB , there is 2 images of the PCB as to not waste transfer paper
IF YOU WISH TO NOT USE A PCB, ALL THE PUSH BUTTONS CAN BE CONNECTED TO GROUND AND AN INDIVIDUAL PIN ( Though the included .ino file will not necessarily map correctly if you don't use the PCB )
