I have been looking for an egg holder that meets all the following requirements:

• can hold at least 10 eggs,
• fits into a refrigerator door compartment (-> not deeper than 100mm),
• keep the eggs stable and safe when removing the entire holder from the refrigerator and
• can be produced with a standard heatbed (200x200mm).

Because I didn't find such a model, I designed it myself.

A single holder measures 50x100mm and holds two eggs. Several holders can be connected together in a very stable way.

The printing time for a single holder (two eggs) is almost exactly one hour, 16g filament are needed (@my printer/configuration). Up to four holders can be easily positioned on a 200x200mm heatbed and thus printed in a single job.

The eggs must have a maximum diameter of at least 35mm in order not to slip through the holder. If necessary, the parameters can be adjusted in the Customizer.

To remove a single egg, lift it from the bottom with a finger.

BTW: For a secure stand, at least two holders should be connected to each other.