Designed to adapt a Dlink DCS-932L (or equivalent case model) This fits on the existing screw holes at the upper left corner. You need to pickup up (2) M6-1.0 x 12MM socket cap screw for the extra length when the bracket is mounted. I'm not sure but if you have a replicator 2 it may have the same mounting holes, or maybe not. The camera bracket acts as a replacement for a generic bracket that the camera screws onto. You should print a 200 micron thickness or better. At 300 micron the threads don't work well.

Build laying down with screw threads up. Build at 200 microns or thinner. this was designed with Autodesk Inventor. The lower leg contains a race to tuck in the power wire.