Co-designed coffee bean hopper / container with fgeller (https://www.thingiverse.com/fgeller/about). He has a Eureka Mignon coffee grinder for which he wanted a new hopper with smaller volume so he could easily switch between different types of beans.

The hopper can contain approximately 175cm3.

The main hopper piece has supports designed in which will need to be cut out. No supports needed for any of the other pieces. It is recommended to print main piece with brim.

There are 3 different 'tops' depending on what you prefer.

The stopper has two parts, however 2nd part is not needed to work.

fgeller's version (pictured above) printed on Ender 3.