Electronics box for MKS v1.4 mainboard and 12864 LCD. The back plate has mounting holes for a 40x10mm cooling fan. I designed around a spare Noctua fan I had. All pieces are held together with M3 self tapping screws I got from Amazon. I have also included a test section of the triangle pattern. I used this to make sure my printer settings would be able to print the pattern with minimal problems. The ANET A8 wire length was designed around having the main board mounted half way up the frame. To get full Z travel I needed to extend most of the wires from the extruder assembly. I also printed and used the LCD spacer from mightynozzle to keep the two LCD boards in place but this may not be totally necessary https://www.thingiverse.com/thing:2813298 There are also two zip-tie points inside the case.
Reset button may need to be sanded.

Parts I used: MKS_Gen_V1.4 RepRapDiscount 128x64LCD Noctura 40x10mm fan

M3 Self-Tapping Screws: 6mm x 4 8mm x 4 10mm x 2 16mm x 4 25mm x 4

extra wire Lots of cable ties