A simple camera mount for a Wyze camera, I originally made this more robust but after I viewed the initial prints I opted to simply the design due to the very light weight of the camera itself. Its pretty sturdy if you print it at .2 layer height, with 5 walls, 8 top and bottom layers and 30% infill. I dropped those settings down to 6 top and bottom layers at 20% infill and it was still pretty solid. Dont forget to run the USB wire behind the brace in the wire slot before you screw it to the wall. The hole on the surface can be for your piggy back wire if you're running one. You can also mount the metal disc on the bottom of the round section and hang your camera inverted. If you do that just loop cable through the large hole to the top then behind the brace in the wire slot.