Test.stl bevor print the hole thing!

• I made a Test print with the thread horizontal and it does work but you shoud test it by yourselfe with the Test.stl and screw them togheter.

• In my case it was a bit hard but after a bit of rotating i does work and iv not u can still poor a liitle hot water over it try it severel times but be careful with melting.

• I print it with dimesion oif 75% of Original

• I used Supports with roof and 0.2 mm distanz to top 0.3 mm Sideways Print with 20-30% Infill Gyroid

• 4 Perimeters gives the structure more stability than higher Infillrate

If you like my work a little Tipp is much appreciated