The creeper is one of my favorite designs in Minecraft and i've always wanted one of my own. recently, i got some glow in the dark abs filament and i thought it would be the perfect thing to print but i couldn't find a fully poseable one. i thought for sure some one on thingiverse would have made one by now because of how he moved in the game, i thought it would be a cinch to make it in reality without any major design problem. the closes i found was Conseils's Minecraft Creeper - With Movable Head. = P but it didn't have poseable legs that i imagined, so i add that in and made it a little more filament print friendly for the masses and here it is. enjoy!!

thanks for all of your hard work Conseils

when the print is done,

1. glue the body and head halves together. (if pla i recommend proweld. its made for gluing styrene or polystyrene but it works incredibly well with pla)
2. insert the swivel pin into place at the bottom of the head and top of the body
3. if the holes don't show up in your print for the feet. find a metal rod with a diameter that is close to one of your drill bits and drill a hole in the center of each foot where the hole is suppose to be and do the same for the corresponding part on the body. (the tighter the fit the better)
4. stick a metal rod or wire through the holes across the entire 2 leg assembly and snip off any excess wire.

Now, he should now be ready to creep on anything insight. be careful though, he does tend to blow up if you get to close to him.