Stack mount your Schiit minis. Replacing the factory cover screws with 4-40x1/2" thread perfectly into the Schiit frame.

File was printed in PLA with 100% fill to give the tabs maximum strength. My print of the 3 high unit wanted to lift on one end so I used a 5mm brim. Print with tabs facing up and the holes printed fine without support. I recommend using a #35 bit to clean out the holes. I wanted a little resistance on the screws.

Files include a 2, 3 and 4 high all with 16mm between components. I did include one 3 high short with only 11mm between components which still will allow the factory feet to remain. The tall adhesive style feet that ship with the Vali 2 may have to be moved as to not interfere with the tabs.