UPDATE- Changes on the front sections and the alignment panels to fit better

Prototype files for a double sided Hirracane blaster, a warning that currently these are untested however in theory they should work. Open to all suggestions and recommendations for modifications if the fit or look isn't 100% perfect :)

Some parts you will need to print twice as its two sided, they are as follows: -EDF Slider -EDF Holder

Screw holes are designed for M2 (preferably countersunk) screws (4-8mm), you will need 9 of them to complete the modification.

To complete this mod you will also need: -2x40mm EDF Shrouds (Hobbyking) -2x40mm EDF Fan blades (Hobbyking) -2x Brushed high speed motors (Aftermarket flywheel motors will work) -1 Zeus Blaster with Lipo mod -27mm OD with 24-26mm ID PVC type pipe (Or simular)

NOTE- Removal of the side tac rails will be needed for this to fit

NOTE- I do not currently know the lengths of pipe needed to complete this mod, if anyone completes this mod and would let me know it would be appreciated

NOTE- I know that McMaster clear pipe is commonly used in Hirracane mods, since that is unavaliable in Australia easily I went with the option of 20mm OD PVC from bunnings-Files can be modded at a later date

Assembly instructions Front section/s 1-Insert PVC tube into middle hole of the front alignment panel (Length will be added after testing), and slide panel into position in Zeus feeder. 2- Assemble EDF fan units with motor and slide in EDF holder from the front and make sure the wires slip out of the built in port (Wire from blaster batteries and switches should already be done, diagram for wiring to come soon). 3) Solder/attach said wires to EDF motor 4)Attach appropriate front assembly to the front alignment panel using screws 5)slip in the EDF slider (Raised panel to the stock of the blaster) 6) Put glue in the EDF holders holes and insert onto the front assemblies posts. 7) Screw in the edf grate on the front of the edf holder.

Rear assembly

1. Join the Lower and upper rear sections with glue followed by the top
2. Slip assebly into the rear of the Zeus Ammunition holder
3. Insert the 2 sliders (left and right as labelled) into the assembly
4. slip on the rear assembly guide and screw into the rear assembly 5)Slide the inserted tube back into the guide
5. Slide in the rest of the tubes
6. Slide on the to rear sections as labelled and screw them in from the assemblyguide