This is the first time I have played around with 3D sculpting and I think it turned out pretty good. I'm sure it could be a bit better though.

This is a combination of two different models that I tweaked quite a bit to make it right. I used the model Grumpy Pumpkin and Vampire Bust Sculpt.

I have not printed this yet, but plan too. The only thing that may be a bit of a challenge are the upper fangs.

BTW, you can make the stem a different color by pausing it at the right layer and switching filament. I did this on the Grumpy Pumpkin giving it a brown stem on an orange pumpkin!

Enjoy!