This ink pen works with "Stabilo EASY original" ink cartridges.

Suitable for right- and left-handed use.

The top section has a 3mm hole to where you can attach your own, fancy creations.

• Print these three parts:

  • InkPen_bot.stl
  • InkPen_top.stl
  • InkPen_cap.stl
    I recommend an infill >=80%.

• Stick an ink cartridge into the bottom part.

• Check if the tip looks like on the image ("IngPen_tip.jpg").

• If not, carefully(!) grind or drill the inner of the tip.

• Screw on the top part.

• If there is a gap, use an 8mm drill and manually drill
  into the top part until it fits.

• Design your own PlugOn part with a 3mm hole at the bottom.

• Attach it with a bit of 3mm filament and glue or use a threaded rod.

• Go out and brag about it...

8-D