A tool to make lines parallel to the edge of a piece of material. This will hold anything from a Sharpie to a x-acto.

Full BOM, instructions, and explode view in PDF.

1. Print the parts (I used PLA light infills)
2. Super glue (cyanoacrylate)tube to slide
3. Press short #6 bolt into thumbwheel and into slider
4. Use "magnet on a stick" tool, flashlight, and a #6 bolt to pull nuts into tube
5. Press 1\4-20 nyloc nuts into base
6. Screw in 1\4-20 socket bolts into bottom of base until they protrude the length of the material you are tracing on.

Uploaded in inch