This Item was printed in:REAL-Filament's Natural (Clear) PLA ø1.75.

Slicer: Slic3r Prusa Edition

I had a tapping bit that did not fit the current tapping wrench I have so i made one to allow me use the bit.

Print Settings

Shell Perimeters: 7 Solid top layers: 7 Solid Bottom layers: 7

Infill Infill Density: 30% Infill Pattern: Honeycomb. Infill Overlap Percentage: 20% Skin Overlap Percentage: 20%

Speed Print Speed: 70 mm/s. Travel Speed: 120 mm/s.

Support Enable Support: No.

Build plate Adhesion Build plate adhesion type: Brim. Brim Width: 6mm.