Printing Bed device to fight center (and other locations) sagging. my bed, PCB with aluminum surface, 220x220 mm does sag a bit in the center.

leveling is very stable at the edges,but after 5 years, the bed sag noticeable, so much the first layer shows a variance in extrusion width.

Placed between carriage and heating bed. Rings (small or big) have a grove for the heating bed temp sensor cables.

Lift per turn: 15 um (3.7 um per quarter turn) max Lift: 3.3 mm Height min: 13.5 mm

Height max: adjustable, by z-axis scaling of rings ;-) you can make it higher by simple scale up the ring to the height required.

Required:

• M3x25mm allen screw (easy to turn/adjust underneath heating bed)
• washer (optional)
• M3 nylon nut